Digital Inflator – How To Inflate a Flat Tire
October 12, 2010
No comments
Digital Gauge Operating Instructions:
- Hold the + or – button for approximately 5 seconds until the display flashes. Set the required pressure using the + or – buttons, then wait 2-3 seconds. The display will show the current pressure value to which the tire will be inflated. (Example: Full tire pressure is achieved at 29.999 PSI. Display currently will read 30 PSI when shuts off.)
- Push the ON/OFF button for the inflator to start. When the pressure gaube reaches the pre-set value, the inflator will automatically switch off and the display will show “OFF.”
- The ON/OFF button can be used to override the preset pressure value if required.
To Inflate tires:
- Screw connector on air valve stem.
- Plug power cord into power accessory outlet.
- Set target pressure value (See: Digital Gauge Operating Instructions)
- Press ON/OFF switch.
- The compressor will stop at the pre-set value.
- Press ON/OFF switch again.
